Filter
Top Products
T400 Ozone Analyzer Operator’s Manual Communications Setup and Operation
153
To assign or reset the status flag bit assignments, press:
deletes the
character currently
inside the cursor
brackets.
Press this button repeatedly to cycle
through the available character set:
: Values of can also be set
but are meaningless.
and move
the cursor brackets “
left and right along the
bit string.
SETUP X.X
ID COM1 COM2 EXIT
SETUP X.X
CFG DAS RNGE PASS CLK EXIT
SETUP X.X
VARS DIAG EXIT
Continue pressing until ...
SETUP X.X
EDIT PRNT EXIT
SETUP X.X
INS
SETUP X.X
PRNT EXIT
Continue pressing until desired
flag message is displayed
discards the
new setting
accepts the
new setting
Inserts a the
character at the
current location of the
cursor brackets.
6.7.9. INSTRUMENT ID
Each instrument on a Hessen Protocol network must have a unique identifier (ID
number). If more than one T400 analyzer is on the Hessen network, refer to Section
5.7.1 for information and to customize the ID of each.
06870C DCN6332