Communications Setup and Operation T400 Ozone Analyzer Operator’s Manual
150
6.7.7.2. Editing or Adding HESSEN Gas List Entries
To add or edit an entry to the Hessen Gas List, press:
SETUP X.X GAS ID:[ID Number]
000 ENTREXIT
SETUP X.X HESSEN GAS LIST
<SET SET> EDIT EXIT
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1 COM2 EXIT
SETUP X.X HESSEN VARIATION:TYPE1
<SET SET> EDIT EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE RANGE=500.0 PPB O3= XXXX
<TST TST> CAL SETUP
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
Toggle to set the GAS
ID to 400.
For new list entries
this number will be
displayed as
000.
Continue pressing NEXT until ...
EXIT discards the
new setting
ENTR accepts the
new setting
SETUP X.X O3, 0, 400, REPORTED
PREV NEXT INS DEL EDIT PRNT EXIT
SETUP X.X GAS TYPE:O3
ENTR EXIT
There is only one GAS
TYPE available on
this analyzer: O3
EXIT sets the
gas type to
NONE
SETUP X.X CONC RANGE:0
0ENTREXIT
Toggle to set the
concentration range
for the list entry
SETUP X.X REPORTED:ON
ON ENTR EXIT
Toggle to turn ON/
OFF the REPORT
attribute
SETUP X.X O3, 0, 400, REPORTED
PREV NEXT INS DEL EDIT PRNT EXIT
06870C DCN6332