Filter
Top Products
Communications Setup and Operation T400 Ozone Analyzer Operator’s Manual
138
6.5.2. CONFIGURING ETHERNET COMMUNICATION WITH DYNAMIC HOST
CONFIGURATION PROTOCOL (DHCP)
1. Consult with your network administrator to affirm that your network server is running
DHCP.
2. Access the Ethernet Menu (SETUP>MORE>COMM>INET).
3. Follow the setup sequence as follows:
SETUP X.X COMMUNICATIONS MENU
ID INET COM1 COM2 EXIT
SETUP X.X INST IP: 0.0.0.0
<SET SET> EXIT
SETUP X.X GATEWAY IP: 0.0.0.0
<SET SET> EXIT
SETUP X.X TCP PORT2: 502
<SET SET> EDIT EXIT
EDIT button
disabled
From this point on,
EXIT returns to
COMMUNICATIONS
MENU
Do not alter unless
directed to by Teledyne
Instruments Customer
Service personnel
SETUP X.X HOSTNAME:
<SET EDIT EXIT
SAMPLE ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
SETUP X.X SUBNET MASK: 0.0.0.0
<SET SET> EXIT
SETUP X.X TCP PORT: 3000
<SET SET> EDIT EXIT
SETUP X.X DHCP: ON
SET> EDIT EXIT
DHCP: ON is
default setting.
If it has been
set to OFF,
press EDIT
and set to ON.
SETUP X.X DHCP: OFF
OFF ENTR EXIT
SETUP X.X DHCP: ON
ON ENTR EXIT
Note
It is a good idea to check the INET settings the first time you power up
your analyzer after it has been physically connected to the LAN/Internet
to make sure that the DHCP has successfully downloaded the
appropriate information from you network server(s). The Ethernet
configuration properties are viewable via the analyzer’s front panel
(SETUP>MORE>COMM>INET).
06870C DCN6332