Filter
Top Products
T400 Ozone Analyzer Operator’s Manual T400 Calibration Procedures
187
9.2.3. PERFORMING A BASIC MANUAL CALIBRATION
9.2.3.1. Setting the Expected O
3
Span Gas Concentration
Note It is important to verify the precise O
3
Concentration Value of the SPAN
gas independently.
<TST TST> SETUP
<TST TST> ZERO SETUP
The O3 span concentration value automatically
defaults to .
Make sure that you input the
concentration value of the Gas.
To change this value to meet the actual
concentration of the
gas, enter the number
sequence by pressing the button under each digit
until the expected value is set.
discards the new
setting
accepts the
new setting
06870C DCN6332