Filter
Top Products
T400 Ozone Analyzer Operator’s Manual Communications Setup and Operation
139
Table 6-3: LAN/Internet Default Configuration Properties
PROPERTY DEFAULT STATE DESCRIPTION
DHCP STATUS
On Editable
This displays whether the DHCP is turned
ON or OFF.
INSTRUMENT IP
ADDRESS
Configured by
DHCP
EDIT key disabled
when DHCP is ON
This string of four packets of 1 to 3
numbers each (e.g. 192.168.76.55.) is the
address of the analyzer itself.
GATEWAY IP
ADDRESS
Configured by
DHCP
EDIT key disabled
when DHCP is ON
A string of numbers very similar to the
Instrument IP address (e.g.
192.168.76.1.)that is the address of the
computer used by your LAN to access the
Internet.
SUBNET MASK
Configured by
DHCP
EDIT key disabled
when DHCP is ON
Also a string of four packets of 1 to 3
numbers each (e.g. 255.255.252.0) that
defines that identifies the LAN the device is
connected to.
All addressable devices and computers on
a LAN must have the same subnet mask.
Any transmissions sent devices with
different assumed to be outside of the LAN
and are routed through gateway computer
onto the Internet.
TCP PORT
1
3000
Editable
This number defines the terminal control
port by which the instrument is addressed
by terminal emulation software, such as
Internet or Teledyne API’ APICOM.
HOST NAME
[initially blank] Editable
The name by which your analyzer will
appear when addressed from other
computers on the LAN or via the Internet.
While the default setting for all Teledyne
API analyzers is the model number, the
host name may be changed to fit customer
needs.
1
Do not change the setting for this property unless instructed to by Teledyne API Customer Service
personnel.
Note If the gateway IP, instrument IP and the subnet mask are all zeroes (e.g.
“0.0.0.0”), the DCHP was not successful, in which case you may have to
configure the analyzer’s Ethernet properties manually. Consult your
network administrator.
06870C DCN6332