Filter
Top Products
5. Base Specifications Parameters
38
# Items Details
Setting range (unit)
1181 G96_ax Constant
surface
speed
control
Specify the axis to be targeted for constant surface
speed control.
0: Program specification will be invalidated‚ and the
axis will always be fixed to the 1st axis.
1: 1st axis specification
2: 2nd axis specification
3: 3rd axis specification
4: 4th axis specification
The program specification will be the priority for all
settings other than 0.
0 to 4
1182 thr_F Thread
cutting
speed
Set the screw cut up speed when not using chamfering
in the thread cutting cycle.
0: Cutting feed clamp feedrate
1 to 60000 mm/min: Set feedrate
0 to 60000
(mm/min)
1183 clmp_M M code for
clamp
Set the M code for C-axis clamp in the hole opening
cycle.
0 to 99999999
1184 clmp_D Dwelling
time after
output-
ting M code
for unclamp
Set the dwell time after outputting the M code for C-axis
unclamp in the hole opening cycle.
0.000 to 99999.999
(s)
1185
1186
1187
1188
1189
spd_F1
spd_F2
spd_F3
spd_F4
spd_F5
F1 digit
feedrate
F1
F2
F3
F4
F5
Specify the feedrate for the F command in the F1-digit
command ("#1079 F1 digit" is set to 1).
Feedrate when F1 is issued (mm/min)
Feedrate when F2 is issued (mm/min)
Feedrate when F3 is issued (mm/min)
Feedrate when F4 is issued (mm/min)
Feedrate when F5 is issued (mm/min)
1 to 1000000
(mm/min)
1190
(PR)
s_xcnt
(For L
system
only)
Validate
inclined-axis
control
0: Disable inclined-axis control
1: Enable inclined-axis control
0/1
1191
(PR)
s_angl
(For L
system
only)
Inclination
angle
Specify the inclination angle α of the oblique coordinate
X' axis from the orthogonal coordinate system's X axis.
–80.000 to 80.000
(degree)
1192
(PR)
s_zrmv
(For L
system
only)
Compensati
on at
reference
point return
Specify whether to perform compensation for the base
axis corresponding to the inclined axis at reference
point return.
0: Performs compensation.
1: Does not perform compensation.
0/1