Filter
Top Products
Configuring the Monitor Using a PC
Chapter 4 Configuring the Monitor 31
Connecting the
PC to the
Monitor
Figure 4-2 Service Socket
Connect the cable from the COM1 port of the PC to the service socket (1).
Loading the
Service
Program
1. Switch on both the monitor and the PC.
2. Load the program by doing one of the following:
If the program files are contained in a directory, change to that directory and
enter:
pegserv
If you want to load the program from drive A: (or another drive)
i. Insert the program disk into drive A:
ii. Change to drive A: and enter:
pegserv
If you are using Windows 98/ NT: Start the service program by double-clicking
on the pegserv icon or on the filename pegserv-exe
3. The program is now loaded and ready for use.
Using the
Service
Program
When the program has been loaded onto your PC, the main menu is displayed. (If the
menu is not displayed, an error message is displayed along the bottom of the screen.)