Filter
Top Products
Configuring the Monitor Using a PC
30 Chapter 4 Configuring the Monitor
Installing the
Service
Program
Before you install the program, ensure that the serial port COM1 is set up as follows:
Transmission Rate 9600 BPS
Parity None
Word length (bits) 8
Stop-bits 1
This is done by giving the mode command (
mode com1:96,N,8,1) at the DOS
prompt. Refer to your MS-DOS Manual for details.
To install the program:
1. Switch on the PC.
2. Create a directory for the program files. For example, to create a directory called
service, at the DOS prompt type in:
md service
and press Enter.
3. Insert the program disk into drive A.
4. At the DOS prompt type
A: and press Enter.
5. At the A: prompt, type:
copy pegserv.exe c:\service
and press Enter. Where service is the directory you created to contain the
program files.
The program is copied to
c:\service
Make sure that the serial interface configuration on the PC is set up as follows:
Datacom-Configuration
Parameter Serial
Transmission Rate (BPS)9600
Word Length (bits) 8
Stop-Bits 1
Parity None
%ON /%OFF Pacing Off
CTS Line Regard
DSR Line Regard
DCD Line Ignore
Power to Interface Off