Filter
Top Products
Recorder Board
Chapter 11 Replacing Parts 145
Recorder Board
To remove the recorder board:
Remove the top cover.
1. Disconnect the cables G, H, I, K, and L.
2. Remove the three screws (1 x S1, 2 x S2). The S2 screws are longer than the S1 screw.
3. Remove the cable J.
4. Lift out the board.
To refit the recorder board:
1. Slide the board into the slot. To give a good electrical contact, the board is tensioned
when screwed down.
2. Refit the screws and screw down the board.
Figure 11-12Refitting the Recorder Board
After refitting the board, carry out the Parameter Test (see page 68).