Filter
Top Products
Chapter 4 Configuring the Monitor 25
4
Configuring the Monitor
Introduction
This chapter describes how to configure the monitor including time and date format, paper
speed, and IUP scale. You can configure the monitor using any of the following methods:
Pushbuttons
Barcode Reader
PC
The tasks you can carry out are summarized in Table 4-1. To find out how to set the current
time, date, and paper speed, see Chapter 5, “Setting Time, Date, and Paper Speed.”
Table 4-1Configuration Tasks
Task Buttons
Barcode
Reader
PC
Configure the time format ✓✓✓
Configure the date format ✓✓✓
Configure the IUP format ✓✓✓
Configure the paper format ✓✓✓
Configure the recorder print offset ✓✗✓
Configure the recorder heat adjust ✓✗✓
Configure the language option ✓✗✗
Marker for alert acknowledgement at Marker button ✓✗✗
Configure note transmission on/off ✓✗✗
Configure interface setting ✓✗✗
Read the options installed ✗✗✓
Run the cyclic test
✗
1.
✗✓
Run the permanent test
✓
2.
✗✗
Read the error log ✗✗✓
Print the error log
✓
2.
✗✗
Clear the error log
✓
2.
✗✓
Write the serial number and set the options ✓✗✓
Enable fetal pulse oximetry interface ✓
✗
✗
Enable maternal blood pressure interface ✓✗✗
Enable NST timer, paper out alert ✓
✗
✗
1. However you can run the Permanent Test, which is similar. See page 70 for details.
2. See “Printing the Error Log” on page 38 for details