Filter
Top Products
Honeywell
MK XXII EGPWS Installation Manual
CAGE CODE: 97896 SCALE: NONE SIZE: A DWG NO: 060-4314-225 REV: C
SHEET
230
Table E 3.1.6-255 Honeywell SPZ8000 (w/ SCI range)
Display Configuration Group 255 (Honeywell SPZ8000 older style)
Function Value
Display Type Honeywell (5x6) (SPZ8000) older style; does not blank every fourth
weather radar display line. This interface supports SG-810 and SG-
811 SPZ8000 systems only.
Sweep Type Honeywell
Auto Pop Up
Category 7, Options Select Group #1
TA&D Alternate Pop Up: False TA&D Alternate Pop Up: True
Pop Up On Caution or Warning Never Pop Up
Peaks Mode
Category 7, Options Select Group #1
(Elevations via overlay)
Peaks Enable: False Peaks Enable: True
Peaks Off Peaks On
Manual select Controlled by SPZ8000 display system
Manual deselect Controlled by SPZ8000 display system
Auto Range Yes (10 NM)
Moving Marker Yes (Honeywell type)
Overlay Page Yes, for Peaks Elevations (located on lower right side)
Display bus type Honeywell picture bus
TERRAIN DISPLAY BUS #1
453TX_1
CONNECT TO:
A = J1-58
B = J1-59
Terrain Display data to switching relay/Symbol Generator #1
TERRAIN DISPLAY BUS #2
453TX_2
CONNECT TO:
A = J1-56
B = J1-57
Terrain Display data to switching relay/Symbol Generator #2
(NOTE: Range setting always follows Display Bus #1).
Display Input Control Group 255
CHANNEL
429_422RX_1
CONNECT TO:
SCI Bus 1
(RS-422 - 12K baud)
Fault Designation: DISPLAY BUS 1
Bus Type: Basic
A = J2-36
B = J2-37
Data
Range (Mode/Range Word)
Label
80
Sig. Bits
4 Discrete
Range
2000NM
Signal Type
Basic
Resolution
N/A
Rate (ms)
100
OUTPUT 429 BUS GROUP 0
Channel Pins Comments
429TX_1 (Low Speed) A = J2-43 B = J2-42 Transmits (Section 7) Label sets: 7.1.1.x, 7.1.2.x, 7.1.3.x and 7.1.4.x
429TX_2 A = J2-26 B = J2-9 No Connection (No Data Output)
Integration Notes:
•
The EGPWS ARINC 429 Output Bus must be connected to the SPZ8000 display.
•
This display type may also be used for an integrated P880/660/440 display, but requires Auto Pop Up to be disabled and
relay selection to be controlled directly from an alternate action switch (for new installations of P880/660/440 use ID
13).