Filter
Top Products
Honeywell
MK XXII EGPWS Installation Manual
CAGE CODE: 97896 SCALE: NONE SIZE: A DWG NO: 060-4314-225 REV: C
SHEET
214
Table E 3.1.6-13 Integrated Honeywell P880/660/440 (WXPD w/ SCI range)
Display Configuration Group 11 (Honeywell Integrated P880/660/440).
Function Value
Display Type Honeywell Integrated P880/660/440 radar displays
Sweep Type Honeywell
Auto Pop Up
Category 7, Options Select Group #1
TA&D Alternate Pop Up: False TA&D Alternate Pop Up: True
Pop Up On Caution or Warning Never Pop Up
Peaks Mode
Category 7, Options Select Group #1
Peaks Enable: False Peaks Enable: True
Peaks Off Peaks On
Manual select Anytime
Manual deselect Anytime
Auto Range No
Moving Marker Yes (across bottom of display)
Overlay Page Yes, for Peaks Elevations only
Display bus type Honeywell picture bus
TERRAIN DISPLAY BUS #1
453TX_1
CONNECT TO:
A = J1-58
B = J1-59
Terrain Display data to switching relay/Symbol Generator #1
TERRAIN DISPLAY BUS #2
453TX_2
CONNECT TO: Not supported for this display type
DISPLAY INPUT CONTROL GROUP 3
CHANNEL
429_422RX_1
CONNECT TO:
SCI Bus 1
(RS-422 - 12K baud)
1.1.1.1.1.1 Fault Designation: DISPLAY BUS 1
Bus Type: Basic
A = J2-36
B = J2-37
Data
Range (Mode/Range Word)
Label
80
Sig. Bits
4 Discrete
Range
2000NM
Signal Type
Basic
Resolution
N/A
Rate (ms)
100
CONN PIN # REFERENCE NAME PIN FUNCTION Polarity/Configuration
J1-32 GND_DISC_12 Display Select Discrete #1 Type 1 (Momentary)
Gnd = Display Select Toggle
<not> Gnd = Normal
OUTPUT 429 BUS GROUP 0
Channel Pins Comments
429TX_1 (Low Speed) A = J2-43 B = J2-42 Transmits (Section 7) Label sets: 7.1.1.x, 7.1.2.x, 7.1.3.x and 7.1.4.x
429TX_2 A = J2-26 B = J2-9 No Connection (No Data Output)
Integration note: