Filter
Top Products
Honeywell
MK XXII EGPWS Installation Manual
CAGE CODE:
97896
SCALE: NONE SIZE: A DWG NO: 060-4314-225 REV: C SHEET
111
To obtain a copy of the WinVIEWS software, contact:
Honeywell
Aerospace Electronic Systems
PO Box 97001
Redmond, WA 98073-9701 USA
Attn: Order Administration M/S 33
Phone: (425) 885-8719
FAX: (425) 885-8988
or
Honeywell
Aerospace Electronic Systems
PO Box 97001
Redmond, WA 98073-9701 USA
Attn: EGPWS Applications Engineering
Phone: (425) 885-3711
FAX: (425) 885-2994
GPWS Hotline: (800) 813-2099
WinVIEWS can be sent via e-mail when an e-mail address is provided or downloaded from the
web (www.egpws.com)
4.4.4 WinVIEWS Operation
1. Connect the PC to the EGPWC using the RS-232 cable as described in section 4.4.2.
2. On the PC, start Windows 3.1, or higher.
3. Start the WinVIEWS.EXE program.
4. Use F6 to select the Terminal Mode. Various commands are available in this mode. Type
“HELP” or “?” for a list of the commands available.
4.5 Configuration Module Programming
The EGPWC reads the aircraft configuration from the Configuration Module, which is installed in
the EGPWC connector. The Configuration Module must have the aircraft specific configuration ID
string written to it before the EGPWS is operational. The ID string is defined by 15 separate
categories listed in Appendix E Table 5.2, Category ID Selection Procedure.
For programming the Configuration Module, the following procedure is used:
1. Verify EGPWC interface to P2 connector (including Configuration Module) and RS-232
interface to PC.
2. Power EGPWC and PC and start WinVIEWS.
3. With WinVIEWS active in the Terminal Mode, configuration sub-mode commands are
available for programming purpose. Type “CFG” at the Terminal Mode prompt (>). At this
point, the CFG> prompt is displayed and the program and EGPWC are ready for entering the
program command and data string. Type “HELP” or “?” to display a list of the Terminal Mode
commands and their description. “CUW” is the preface command for entering the ID string.
4. Using the Category ID’s as chosen from the Appendix E (refer to completed Table 5.2),
create a command string with the following structure:
CUW 0/15 # # # # # # # # # # # # # # #/