Filter
Top Products
5 - 30 5 - 30
5 ADDED FUNCTIONS TO CORRESPOND TO A SAFETY
PROGRAMMABLE CONTROLLER
MELSOFT
(3) Network parameter items of CC-Link Safety
Safety refresh monitoring time
CC-Link
No. of boards in module
Start I/O No.
Operational setting
Station No.
Master station data link type
Mode
Transmission speed
Set the number of modules (1 or 2 modules).
Set the start I/O No.
Set "Parameter name" and "Case of CPU STOP setting".
Set the number of remote station for which a loop test is
performed.
The setting is fixed to "PLC parameter auto start".
Set the mode.
Set the transmission speed of the CC-Link Safety master
module.
Set the monitoring time for communications between a
safety master station and safety remote station.
Set the ID assigned to each CC-Link master module.
Link ID
All connect count
Remote input [RX]
Remote output [RY]
Remote register [RWr]
Remote register [RWw]
Special relay [SB]
Special register [SW]
Retry count
Automatic reconnection station count
Set the number of modules connected (1 to 64 modules).
Set the devices to be batch-refreshed.
Set the devices to be batch-refreshed.
Set the devices to be batch-refreshed.
Set the devices to be batch-refreshed.
Set the devices to be batch-refreshed.
Set the devices to be batch-refreshed.
Set the number of transmission retries.
Set the number of stations automatically reconnected
during one scan.
Safety data monitoring time
Set the monitoring time between safety input and output.
Scan mode setting
Station information setting
Specify either synchronous or asynchronous with
the sequence scan.
Set the station type, number of occupied stations,
safety remote station settings, etc.