Filter
Top Products
5 - 29 5 - 29
5 ADDED FUNCTIONS TO CORRESPOND TO A SAFETY
PROGRAMMABLE CONTROLLER
MELSOFT
5.5.2 Setting network parameters
The following shows the network parameter items list. For information and details
required for the parameter settings, refer to the user's manual of the corresponding
network module.
(1) Network parameter items of MELSECNET/10, MELSECNET/H, and CC-Link IE
Controller Network
Network type
Starting I/O No.
Set the first I/O No.
Network No.
Set the network No.
Group No.
Set the group No.
Mode
Set the mode.
Refresh parameters
Set the refresh parameters.
Specify the MELSECNET/H·MELSECNET/10 mode or
CC-Link IE Controller Network.
Station No.
(CC-Link IE Controller Network only)
Set the station number.
MELSECNET/10
MELSECNET/H
CC-Link IE Controller Network
(2) Network parameter items of Ethernet
Ethernet
Network type
Starting I/O No.
Set the starting I/O No.
Group No.
Set the group No.
Station No.
Set the station number.
Mode
Set the mode.
Specify Ethernet.
Operational settings
Initial settings
Make the timer setting and DNS setting.
Open settings
Make the open settings.
Router relay parameter
Station No. IP information
Make the communications data code setting,
initial timing setting and IP address setting.
Set the router relay function, sub-net mask
pattern, default router IP address, etc.
Set the MNET/10 routing system, net mask
p
attern, etc.
Network No.
Set the network No.