Filter
Top Products
Section 1
General Information
4-10 Programming & Operation MN722
Parameter Definitions
Converter Control Board Parameters
Converter section parameters are programmed at the factory. Table 4-1 is a list of the
parameters that can be changed. However, to make any parameter adjustments the
keypad must be installed in the Converter Control Board as described previously in this
section. Each Converter section parameter is defined in Table 4-2.
Table 4-1 Converter Section Parameter List
LEVEL 1 BLOCKS
Miscellaneous
Factory Settings
Line Inductor
Bus Capacitance
DAC Selection
Security Control
Security State
Access Timeout
Access Code