Mitsubishi Electronics C64T Crib Toy User Manual


 
Introduction
This manual is a guide of the parameters used with the CNC MELDAS C6/C64/C64T.
This manual is written on the assumption that all machine parameters of the MELDAS
C6/C64/C64T are provided. However, the CNC may not necessarily be provided with all
of the options. When the system is used, therefore, reference should be made to the
Specifications Manual issued by the machine maker.
Points to be observed when reading this manual
(1) This manual contains general descriptions as seen from the standpoint of NC
(numerical control) and thus refer to the Instruction Manual issued by the machine
maker for descriptions of individual machine tools.
The Instruction Manual issued by the machine maker takes precedence over this
manual when any mention of "restrictions", "usable states" or such details are
mentioned.
(2) As much information as possible on special procedures has been included in this
manual, and it may be considered that any procedures not mentioned cannot be
undertaken.
(3) Also refer to the following manuals.
MELDAS C6/C64/C64T Instruction Manual........................................ BNP-B2259
MELDAS C6/C64/C64T Programming Manual
(Machining center/Transfer machine system)........ BNP-B2260
MELDAS C6/C64/C64T Programming Manual (Lathe system) .......... BNP-B2264
MELDAS AC Servo MDS-B-Vx Series Servo Parameter Manual....... BNP-A2993
MELDAS AC Servo MDS-C1 Series Specification Manual................. BNP-C3000
CAUTION
For items described as "Restrictions" or "Usable State" in this manual, the Instruction
Manual issued by the machine maker takes precedence over this manual.
Items that are not described must be interpreted as "not possible".
This manual is written on the assumption that all option functions are added. Refer to the
Specifications Manual issued by the machine maker before starting use.
Refer to the manuals issued by the machine manufacturer for each machine tool
explanation.
Some screens and functions may differ or may not be usable depending on the NC system
version.