Mitsubishi Electronics C64T Crib Toy User Manual


 
8. Spindle Parameters
8.3 MDS-B-SP/SPH, MDS-C1-SP/SPH
219
No. Items Details
Setting
range
Standard
setting
3320 SP120 MPGL Orientation
position gain
L winding
compensa-
tion magnifi-
cation
Set the compensation magnification of the
orientation position loop gain for the L
winding.
L winding orientation position loop gain
= SP001 (or SP002) × SP120/256
When set to "0", will become the same as
SP001 or SP002.
0 to 2560
(1/256-fold)
0
3321 SP121 MPCSH Orientation
deceleration
rate H
winding
compensa-
tion magnifi-
cation
Set the compensation magnification of the
orientation deceleration rate for the H
winding.
Orientation deceleration rate for the H
winding
= SP006 × SP121/256
When set to "0", will become the same as
SP006.
0 to 2560
(1/256-fold)
0
3322 SP122 MPCSL Orientation
deceleration
rate L
winding
compensa-
tion magnifi-
cation
Set the compensation magnification of the
orientation deceleration rate for the L
winding.
Orientation deceleration rate for the L
winding
= SP006 × SP122/256
When set to "0", will become the same as
SP006.
0 to 2560
(1/256-fold)
0
3323 SP123 MGD0 Magnetic
sensor
output peak
value
This parameter is used for adjustment of
orientation operation of the magnetic sensor.
Set the output peak value of the magnetic
sensor.
If a gap between the sensor and the
magnetizing element is small, increase the
value of this parameter. If it is large,
decrease the value of this parameter.
1 to 10000 Standard
magnetizin
g element:
542
Small
magnetizin
g element:
500
3324 SP124 MGD1 Magnetic
sensor
linear zone
width
This parameter is used for adjustment of
orientation operation of the magnetic sensor.
Set the linear zone width of the magnetic
sensor.
If the radius of the mounted magnetizing
element is large, decrease the value of this
parameter. If it is small, increase the value of
this parameter.
1 to 10000 Standard
magnetizin
g element:
768
Small
magnetizin
g element:
440