Mitsubishi Electronics C64T Crib Toy User Manual


 
5. Base Specifications Parameters
23
# Items Details
Setting range (unit)
1073 I_Absm Initial
absolute
value
Specify the absolute value/incremental value mode for
when the power is turned on or reset.
0: Incremental
value command
mode
1: Absolute value
command
mode
1074 l_Sync Initial
synchronous
feed
Specify the feedrate specification mode for when the
power is turned on or reset.
0: Asynchronous feed (feed per minute)
1: Synchronous feed (feed per rotation)
0: Asynchronous
feed
1: Synchronous
feed
1075 I_G00 Initial G00 Specify the linear command mode for when the power
is turned on or reset.
0: Linear interpolation (G01 command state)
1: Positioning (G00 command state)
0: Linear
interpolation
1: Positioning
1076 Abslnc
(For L
system
only)
ABS/INC
address
The absolute value/incremental commands can be
issued by using the absolute value address and
incremental value address for the same axis.
0: Absolute/incremental with G command
1: Absolute/incremental with address code
(The "#1013 axname" address will be the
absolute value command‚ and "#1014 incax"
address will be the incremental value command)
0: Absolute/
incremental
with G
command
1: Absolute/
incremental
with address
code
1077 radius Incremental
command
for diameter
specification
axis
Specify if the diameter specification axis’ ("#1019 dia" is
set to 1) incremental value command uses the diameter
value or radius value
0: Diameter value
1: Radius value
1078 Decpt2 Decimal
point type 2
Specify the unit of position commands that do not have
a decimal point.
0: The min. input command unit is used (follows
"#1015 cunit")
1: 1mm (or 1inch) unit is used
0: The min. input
command unit
is used
1: 1mm (or 1inch)
unit is used
1079 F1digt Validate F1
digit
Specify whether to execute the F command with a
1-digit code command or with a direct numerical
command.
0: Direct numerical command (command feedrate
during feed per minute or rotation)
1: 1-digit code command (feedrate specified with
"#1185 spd_F1" to "#1189 F5")
0: Direct
numerical
command
1: 1-digit code
command