Filter
Top Products
Chapter 5 Work in Edit mode 78
Edit assignments and mappings
Using the Assign & Map button, you can also edit existing assignments and mappings in the
Assignments & Mappings table.
Edit an existing assignment or mapping
1 In the Assignments & Mappings table, select the assignment you want to edit.
2 Click the Assign & Map button.
3 To change the assignment, manipulate the hardware control you want to assign.
The table is updated to show the new assignment.
4 To change the mapping, do one of the following:
•
Select a new mapping parameter or action in the Screen Control Inspector.
•
Click a parameter on a channel strip or a plug-in window.
The table is updated to show the new mapping.
Edit Hardware Input parameters
You can view and edit the Hardware Input parameters for an assignment in the Assignments
& Mappings table, allowing you to quickly modify the assignment without leaving Edit mode.
For detailed information about particular Hardware Input parameters, see Screen controls
overview on page 102.
Edit Hardware Input parameters for an assignment
1 Click the assignment you want to edit.
2 In the dialog that appears, choose new Hardware Input parameters for the assignment from the
pop-up menus.
3 When you are nished, click Done, or click anywhere outside the dialog.
Block incoming controller messages
You can block incoming controller messages that you do not want MainStage to process. To
block incoming controller messages, the controller must not be assigned to any screen control.
Block unassigned controller messages
1 In the Assignments & Mappings table, select the text “Unassigned” in the Assignment column.
2 In the Screen Control Inspector, deselect the Send all unassigned MIDI to Channel
Strips checkbox.