Filter
Top Products
Appendix A The Playback plug-in 133
Use the Playback group functions
If you have multiple instances of the Playback plug-in in a concert, you can use groups to
control which instances play together and which instances operate independently. Any Playback
instance can either be assigned to one of 100 groups, or not be a member of any group. The
linked operation of multiple instances can be used for creative playback purposes, such as
alternative versions of a song verse or chorus.
Only one group can be active at a time. For example, if two Playback instances are in Group 1,
and four Playback instances are in Group 2, activation of a transport function in any Group 1
member will stop playback of all Group 2 members, and vice versa. Instances that are not in any
group are not aected.
All Playback instances that belong to a group will switch between states for the following
transport functions when changed in any group member:
•
Return to Start
•
Play or Stop
•
Dragging in the waveform display
•
Cycle
•
Fade Out (time and action)
•
Go to Previous (or Next) Marker
Important: Editing a parameter in one member of a group does not automatically update the
parameter value in other group members. To change the parameter value in all group members,
hold down Shift while you edit the parameter in any group member. This applies to the Meter,
Fade Time, Pitch, Sync, Snap To, and Play From parameters. You need to set Sync to the same
mode for all group members or you will hear playback drift between grouped instances.
Assign a Playback instance to a group
m Open the Group pop-up menu at the lower right of the interface and choose a letter.
Note: When a Playback instance is added to an existing group, some button states may be
dierent from other group members. If you want all group members to behave identically when
a transport button is used in any group member, make sure that the states of all buttons match
those of other group members before you add a Playback instance to a group.
Remove a Playback instance from all groups
m Choose the “–” item from the Group pop-up menu.