Appendix B The Loopback plug-in 144
•
Undo button: When pressed during playback or when stopped, removes the most recently
recorded take from the tape loop. Pressing Undo during the rst beat of a new take removes
the previously recorded take.
Loopback information display
The information display shows information about several key aspects of the audio material in the
tape loop and lets you edit some of the displayed values.
Information Display parameters
•
Position eld: Indicates the current playhead position.
•
Length eld: Displays the length of the loop.
If Sync is set to O, Loopback analyzes the rst take and determines the tempo and length,
using the concert tempo as a starting point. After the length is set, it cannot be changed (until
you clear the tape loop).
If Sync is set to On, you can set the length (in the information display, or using a screen
control) before you record the rst take. If you do not set the length, Loopback analyzes the
rst take and sets the length using the concert tempo, rounding up to the next whole bar.
•
Position dial: Displays the current playback position in the context of the overall loop length.
•
Meter eld: Displays the meter (time signature) of the audio material. The bar and beat values
can be altered independently, which changes the ruler display and may alter the Length
eld display, but does not aect audio playback. It cannot be changed once the length is set
without rst clearing the tape loop.
•
Tempo eld: Displays the tempo in beats per minute. The tempo is “locked” after the rst
recording and cannot be changed.
•
Fade Time eld: Indicates the fade-out time in seconds. Drag vertically to adjust this value. See
Loopback transport and function controls on page 143.