D-Link DWS-1008 CLI Manual 136
The following command configures community string switchmgr1 with access level notify-read-
write:
DWS-1008# set snmp community name switchmgr1 notify-read-write
success: change accepted.
See Also:
• clear snmp community
• set ip snmp server
• set snmp notify target
• set snmp notify profile
• set snmp protocol
• set snmp security
• set snmp usm
• show snmp community
set snmp notify profile
Configures an SNMP notification profile. A notification profile is a named list of all the notification
types that can be generated by a switch, and for each notification type, the action to take (drop
or send) when an event occurs.
You can configure up to ten notification profiles.
Syntax: set snmp notify profile {default | profile-name}
{drop | send} {notification-type | all}
default | profile-name Name of the notification profile you are creating or modifying. The
profile-name can be up to 32 alphanumeric characters long, with no
spaces.
To modify the default notification profile, specify default.
drop | send Specifies the action that the SNMP engine takes with regard to the
notifications you specify with notification-type or all.
notification-type Name of the notification type:
• APBootTraps—Generated when an access point boots.
• ApNonOperStatusTraps—Generated to indicate an AP radio is nonoperational.
• ApOperRadioStatusTraps—Generated when the status of an AP radio changes.
• APTimeoutTraps—Generated when an access point fails to respond to the switch.
• AuthenTraps—Generated when the switch’s SNMP engine receives a bad community
string.
• AutoTuneRadioChannelChangeTraps—Generated when the RF Auto-Tuning feature
changes the channel on a radio.
