Filter
Top Products
PERF SONG PATTERN MIX MASTER REMOTE UTILITY
QUICK SET
FILEVOICE
MOXF6/MOXF8 Reference Manual
Song Mode
Song Play
[F1] PLAY
[F2] GROOVE
[F3] TRACK
[F6] CHAIN
Song Record
Song Record Standby
[F1] SETUP
[F2] VOICE
[F3] ARP ED
[F5] CLICK
[F6] ALL TR
During Song Recording
[F1] SETUP
[F3] REST
[F4] TIE
[F5] DELETE
[F6] BAK DEL
Arpeggio Edit
[F1] COMMON
[F2] TYPE
[F3] MAIN
[F4] LIMIT
[F5] PLAY FX
[F6] OUT CH
Song Edit
[F1] CHANGE
[F2] VIEW FLT
[F4] TR SEL
[F5] INSERT
[F6] DELETE
Song Job
[F1] UNDO/REDO
[F2] NOTE
[F3] EVENT
[F4] MEAS
[F5] TRACK
[F6] SONG
Supplementary Information
99
Song Track Loop – setting example
In the example below, a 40-measure Song has been recorded and Track 1 is set to play back normally over the 40
measures. Track 2 has been set to loop, and will repeat until the [ ] (Stop) is pressed.
When set to on, you can specify the range to be looped. (Only the end point can be set; the start point of looped
playback is fixed to the beginning of the Song.)
NOTICE
Please be careful to note that changing the Track Loop from off to on will delete the data of the area that is not looped.
1
Press the [F1] PLAY button to call up the Song Play display. Set the last measure of looped
playback as desired here.
2 Press the [F3] TRACK button and then press the [SF3] TR LOOP button to call up the Track Loop
display, and move the cursor to the desired Track.
3 Set Track Loop to on by using the [INC] button or the [DATA] dial. (The display prompts you for
confirmation.)
4 Press the [INC] button. The Loop is set to on and the part that is not looped is deleted.
If you want to restore the deleted data and return the selected Track to off, press the [SF6] UNDO button.
NOTICE
The Undo function can only be used on the last Track Loop operation. If you’ve set other Tracks to loop, the original data of those
previously edited Tracks cannot be recovered.
NOTICE
If you move to another display, the Undo function cannot be executed.
Tra ck 1
(40 measures of data)
Tra ck 2
(40 measures of data)
Playback
The four-measure data is repeated ten times
In this example, the last measure is set to “004.”