Filter
Top Products
PERF SONG PATTERN MIX MASTER REMOTE UTILITY
QUICK SET
FILEVOICE
MOXF6/MOXF8 Reference Manual
Voice Mode
Voice Play
[F1] PLAY
[F3] PORTA
[F4] EG
[F5] ARP ED
[F6] EFFECT
Arpeggio Edit
[F2] TYPE
[F3] MAIN
[F4] LIMIT
[F5] PLAY FX
Normal Voice Edit
Common Edit
[F1] GENERAL
[F2] OUTPUT
[F3] EQ
[F4] CTL SET
[F5] LFO
[F6] EFFECT
Element Edit
[F1] OSC
[F2] PITCH
[F3] FILTER
[F4] AMP
[F5] LFO
[F6] EQ
Drum Voice Edit
Common Edit
[F1] GENERAL
[F2] OUTPUT
[F3] EQ
[F4] CTL SET
[F6] EFFECT
Key Edit
[F1] OSC
[F2] PITCH
[F3] FILTER
[F4] AMP
[F6] EQ
Voice Job
[F1] INIT
[F2] RECALL
[F3] COPY
[F4] BULK
Supplementary Information
46
KeyOnReset
Determines whether or not the LFO is reset each time a note is played.
Settings: off, on
KeyOnDelay
Determines the delay time between the moment that a Note On message is received and the moment the LFO comes
into effect.
Settings: 0 – 127
PMod (Pitch Modulation Depth)
Determines the amount (depth) by which the LFO waveform varies (modulates) the pitch of the sound.
Settings: 0 – 127
FMod (Filter Modulation Depth)
Determines the amount (depth) by which the LFO waveform varies (modulates) the Filter Cutoff frequency.
Settings: 0 – 127
AMod (Amplitude Modulation Depth)
Determines the amount (depth) by which the LFO waveform varies (modulates) the amplitude or volume of the sound.
Settings: 0 – 127
FadeInTime
Determines the amount of time for the LFO effect to fade in (after the “KeyOnDelay” time has elapsed).
Settings: 0 – 127
Type
Determines the Equalizer Type.
Settings: 2 Band, P.EQ (Parametric EQ), Boost6 (boost 6dB), Boost12 (boost 12dB), Boost18 (boost 18dB), thru
2 Band.....................................This is a “shelving” equalizer, which combines separate high and low frequency bands.
P. E Q ( Pa r a me t ri c E Q ) . . .. . . .. . .. . . . T he Pa r am e t ri c E Q i s u se d t o attenuate or boost signal levels (gain) around the Frequency. This
type features 32 different “Q” settings, which determine the frequency band width of the
equalizer.
Boost6 (boost 6dB)/Boost12 (boost 12dB)/Boost18 (boost 18dB)
.................................................These can be used to boost the level of the entire signal by 6dB, 12dB and 18dB, respectively.
thru ..........................................This setting bypasses the equalizers leaving the entire signal unaffected.
[F6] EQ (Equalizer)
Off On
Key on Key on
Time Time
–
+
0
–
+
0
When set to 2 Band When set to P.EQ
Gain
Gain
Low Freq
Settings: 50.1Hz – 2.00kHz
High Freq
Settings: 503.8Hz – 10.1kHz
Frequency
High Gain
Settings: -32 – +0 – +32
Low Gain
Settings: -32 – +0 – +32
Freq
Settings: 139.7Hz – 12.9kHz
Gain
Settings: -32 – +0 – +32
Frequency
Q
Settings: 0 – 31