Filter
Top Products
PERF SONG PATTERN MIX MASTER REMOTE UTILITY
QUICK SET
FILEVOICE
MOXF6/MOXF8 Reference Manual
Mixing Mode
Mixing Play
[F1] VOL/PAN
[F2] VOICE
[F3] EF SEND
[F4] TEMPLATE
[F5] VCE ED
[F6] EFFECT
Mixing Edit
Common Edit
[F1] GENERAL
[F2] MFX
[F3] MEQ
[F4] USB I/O
[F5] A/D IN
[F6] EFFECT
Part Edit
[F1] VOICE
[F2] OUTPUT
[F3] EQ
[F4] TONE
[F5] RCV SW
Mixing Job
[F1] INIT
[F2] RECALL
[F3] COPY
[F4] BULK
Mixing Voice Edit
Common Edit
[F1] GENERAL
[F2] OUTPUT
[F4] CTL SET
[F5] LFO
[F6] EFFECT
Element Edit
[F1] OSC
[F2] PITCH
[F3] FILTER
[F4] AMP
[F5] LFO
[F6] EQ
Mixing Voice Job
[F2] RECALL
[F3] COPY
[F5] DELETE
Supplementary Information
118
[SF3] LIMIT
From this display you can determine the note range and velocity range for each Part. The parameters are the same as in
Performance Part Edit. See page 65.
[SF4] PORTA (Portamento)
Determines the Portamento parameters for each Part. The parameters are the same as in Performance Part Edit. See
page 65.
[SF5] VEL SENS (Velocity Sensitivity)
The parameters are the same as in Performance Part Edit. See page 65.
[SF6] OTHER
The parameters are the same as in Performance Part Edit. See page 66.
Determines the Voice for each Part. This display shows only four Parts at a time (Part 1 – 4, Part 5 – 8, Part 9 – 12, or Part
13 – 16). To switch the editable Parts, press the Cursor [<]/[>] buttons. The editable Parts can be also switched by
pressing the corresponding buttons to other Parts of numbers [1] – [16] after pressing the [TRACK] button.
[SF1] VOL/PAN (Volume/Pan)
The parameters are the same as in Performance Part Edit. See page 66.
[SF2] EF SEND (Effect Send)
The parameters are the same as in Performance Part Edit. See page 66.
From this display you can set parameters related to the Part EQ. The parameters are the same as in Performance Part
Edit. See page 67.
[SF1] TUNE
The parameters are the same as in Performance Part Edit. See page 68.
[SF2] FILTER
The parameters are the same as in Performance Part Edit. See page 68.
[SF3] FEG (Filter EG)
From this display you can set the FEG parameters for each Part. The parameters offset the same parameters of the
assigned Voice set in the Voice mode (page 42). The parameters are the same as in Performance Part Edit. See page
68.
NOTE
These FEG parameters are not available for the Parts to which Drum Voices have been assigned.
[F2] OUTPUT
[F3] EQ (Equalizer)
[F4] TONE