Filter
Top Products
PERF SONG PATTERN MIX MASTER REMOTE UTILITY
QUICK SET
FILEVOICE
MOXF6/MOXF8 Reference Manual
Voice Mode
Voice Play
[F1] PLAY
[F3] PORTA
[F4] EG
[F5] ARP ED
[F6] EFFECT
Arpeggio Edit
[F2] TYPE
[F3] MAIN
[F4] LIMIT
[F5] PLAY FX
Normal Voice Edit
Common Edit
[F1] GENERAL
[F2] OUTPUT
[F3] EQ
[F4] CTL SET
[F5] LFO
[F6] EFFECT
Element Edit
[F1] OSC
[F2] PITCH
[F3] FILTER
[F4] AMP
[F5] LFO
[F6] EQ
Drum Voice Edit
Common Edit
[F1] GENERAL
[F2] OUTPUT
[F3] EQ
[F4] CTL SET
[F6] EFFECT
Key Edit
[F1] OSC
[F2] PITCH
[F3] FILTER
[F4] AMP
[F6] EQ
Voice Job
[F1] INIT
[F2] RECALL
[F3] COPY
[F4] BULK
Supplementary Information
39
Wave Bank
Determines the Waveform Bank assigned to the Element. The available Banks are Preset (“pre”) and User (“user”). The
Preset Bank includes the preset Waveforms while the User Bank includes the User Waveforms (stored to the optional
Flash Memory Expansion Module).
Settings: pre, user
WaveCategory (Waveform Category)
WaveNumber (Waveform Number)
Determines the Waveform for the selected Element. See the “Waveform List” in the “Data List” PDF document.
[SF2] OUTPUT
From this display you can set certain output parameters for the selected Element.
KeyOnDelay
Determines the time (or elapsed delay) between the moment you press a note on the keyboard and the point at which
the sound is actually played. You can set different delay times for each Element.
Settings: 0 – 127
DelayTempoSync
Determines whether or not “KeyOnDelay” is synchronized to the tempo of the Arpeggio or sequencer (Song or Pattern).
Settings: off (not synchronized), on (synchronized)
DelayTempo
Determines the timing of “KeyOnDelay” when “DelayTempoSync” is set to on.
Settings: 16th, 8th/3 (eighth-note triplets), 16th. (dotted sixteenth notes), 8th, 4th/3 (quarter-note triplets), 8th. (dotted eighth notes), 4th
(quarter notes), 2nd/3 (half-note triplets), 4th. (dotted quarter notes), 2nd (half notes), whole/3 (whole-note triplets), 2nd.
(dotted half notes), 4thx4 (quarter-note quadruplets; four quarter notes to the beat), 4thx5 (quarter-note quintuplets; five quarter
notes to the beat), 4thx6 (quarter-note sextuplets; six quarter notes to the beat), 4thx7 (quarter-note septuplets; seven quarter
notes to the beat), 4thx8 (quarter-note octuplets; eight quarter notes to the beat)
InsEffectOut (Insertion Effect Out)
Determines which Insertion Effect (A or B) is used to process each individual Element. This parameter is the same as
“EL: OUT” (page 35) on the [F6] EFFECT [SF1] CONNECT display in Normal Voice Common Edit. Making a setting
here automatically changes the setting of that parameter as well.
Settings: thru (through), ins A (insertion A), ins B (insertion B)
[SF3] LIMIT
NoteLimit
Determines the lowest and highest notes of the keyboard range for each Element.
Settings: C -2 – G8
NOTE You can also set the note directly from the keyboard, by holding down the [SF6] KBD button and pressing the desired key.
VelocityLimit
Determines the minimum and maximum values of the velocity range within which each Element will respond.
Settings: 1 – 127
VelCrossFade (Velocity Cross Fade)
Determines how gradually the sound of an Element decreases in volume in proportion to the distance of velocity
changes outside the Velocity Limit setting (above).
Settings: 0 – 127