Filter
Top Products
PERF SONG PATTERN MIX MASTER REMOTE UTILITY
QUICK SET
FILEVOICE
MOXF6/MOXF8 Reference Manual
Utility Mode
[F1] GENERAL
[F2] VOICE
[F2] SEQ
[F3] VCE A/D
[F4] CTL ASN
[F5] USB I/O
[F6] MIDI
Utility Job
145
NOTE Keep in mind that settings other than “off” may result in slower operation—for example, a pause before starting playback, or
slower rewind/fast forward speed.
NOTE When this is set to “all,” an excessive amount of MIDI data may be generated, possibly resulting in a MIDI error on the
connected device.
LoadMix
Determines whether the Mixing settings are loaded (on) or not (off) when the Song/Pattern number is changed.
Settings: off, on
NOTE This setting affects the Song/Pattern changes during Song chain playback.
[SF6] MEMORY
Indicates the remaining free (available) memory for the Sequencer.
You can set parameters related to the audio input signal from the A/D INPUT [L]/[R] jacks in the Voice mode. Details on
each parameter are the same as in Performance Common Edit. See page 62.
[SF1] ASSIGN
Determines Controller Assign settings common to the entire system of the MOXF6/MOXF8. You can assign MIDI Control
Change Numbers to the Knobs on the front panel and the external controllers. For example, you could use the ASSIGN
1 and 2 knobs to control effect depth for two different effects, while using the Foot Controller to control modulation.
These Control Change Number assignments are known as “Controller Assign.”
NOTE
As for controllers that are not actually available on the instrument itself, they can be controlled by transmitting the corresponding
MIDI control number from an external MIDI controller.
BC (Breath Controller Control Number)
Determines the Control Change number generated when you use a Breath Controller on an external device connected
to the MOXF6/MOXF8.
Settings: off, 1 – 95
RB (Ribbon Controller Control Number)
Determines the Control Change number corresponding to a Ribbon Controller on an external device connected to the
MOXF6/MOXF8.
Settings: off, 1 – 95
FC1 (Foot Controller 1 Control Number)
Determines the Control Change number generated when you use the Foot Controller connected to the [FOOT
CONTROLLER] jack. Keep in mind that if the same MIDI Control Change messages as set here are received from an
external device, the internal tone generator also responds to those messages as if the Foot Controller of the instrument
itself was used.
Settings: off, 1 – 95
FC2 (Foot Controller 2 Control Number)
Determines the Control Change number corresponding to a Foot Controller 2 on an external device connected to the
MOXF6/MOXF8.
Settings: off, 1 – 95
AS1 (Assignable 1 Control Number)
AS2 (Assignable 2 Control Number)
Determines the Control Change number generated when you use the ASSIGN 1/2 knobs. Keep in mind that if the same
MIDI Control Change messages as set here are received from an external device, the internal tone generator also
responds to those messages as if the ASSIGN 1/2 knobs of the instrument itself was used.
Settings: off, 1 – 95
[F3] VCE A/D (Voice A/D Input)
[F4] CTL ASN (Controller Assign)