Filter
Top Products
PERF SONG PATTERN MIX MASTER REMOTE UTILITY
QUICK SET
FILEVOICE
MOXF6/MOXF8 Reference Manual
Performance Mode
Performance Play
[F1] PLAY
[F2] VOICE
[F3] PORTA
[F4] EG
[F5] ARP ED
[F6] EFFECT
Arpeggio Edit
[F1] COMMON
[F2] TYPE
[F3] MAIN
[F4] LIMIT
[F5] PLAY FX
[F6] OUT CH
Performance Edit
Common Edit
[F1] GENERAL
[F2] OUT/MFX
[F3] MEQ
[F4] USB I/O
[F5] A/D IN
[F6] EFFECT
Part Edit
[F1] VOICE
[F2] OUTPUT
[F3] EQ
[F4] TONE
[F5] RCV SW
Performance Job
[F1] INIT
[F2] RECALL
[F3] COPY
[F4] BULK
Performance Record
[F1] SETUP
[F2] REC TR
[F3] OTHER
[F5] CLICK
[F6] INFO
Supplementary Information
67
RevSend (Reverb Send)
Set the stereo pan position for each Part. This lets you make detailed Reverb effect adjustments among the various
sounds of the Drum Voice.
Settings: 0 – 127
DryLevel
Determines the level of the unprocessed (dry) sound of the selected Part, letting you control the overall effect balance
among the Parts.
Settings: 0 – 127
InsEF (Insertion Effect Part Switch)
Determines the Parts available for the Insertion Effect. When this switch is set to on, the Insertion Effect of the Voice
assigned to the Part is enabled.
Settings: off, on
From this display you can adjust the EQ settings for each Part. This is a parametric EQ featuring three bands (High, Mid
and Low). You can attenuate or boost the level of each frequency band (High, Mid, Low) to change the Voice sound.
Note that two different display types listed below are provided and you can switch between them by pressing the [SF6].
Each display type features the same settings in a different format; use the type you feel most comfortable with.
•Display showing four Parts
Keep in mind that since all the available parameters cannot be simultaneously displayed in the four-Part display, you
will need to use the cursor controls to scroll the display in order to see and set the other parameters.
•Display showing all parameters for one Part
For details about the Effect connection including the EQ in the Performance mode, see page 20.
FREQ (Frequency)
Determines the frequency for each frequency band.
Settings: Low: 50.1Hz – 2.00kHz
Mid: 139.7Hz – 10.1kHz
High: 503.8Hz – 14.0kHz
GAIN
Determines the level gain for the Frequency (set above), or the amount the selected frequency band is attenuated or
boosted.
Settings: -12.00dB – +0.00dB – +12.00dB
Q
Determines the Q (bandwidth) for the Mid band.
Settings: 0.7 – 10.3
[F3] EQ (Equalizer)
Knob
–
+
0
Gain
Frequency
3 bands Low Mid High
Knob
Knob