Filter
Top Products
PERF SONG PATTERN MIX MASTER REMOTE UTILITY
QUICK SET
FILEVOICE
MOXF6/MOXF8 Reference Manual
Voice Mode
Voice Play
[F1] PLAY
[F3] PORTA
[F4] EG
[F5] ARP ED
[F6] EFFECT
Arpeggio Edit
[F2] TYPE
[F3] MAIN
[F4] LIMIT
[F5] PLAY FX
Normal Voice Edit
Common Edit
[F1] GENERAL
[F2] OUTPUT
[F3] EQ
[F4] CTL SET
[F5] LFO
[F6] EFFECT
Element Edit
[F1] OSC
[F2] PITCH
[F3] FILTER
[F4] AMP
[F5] LFO
[F6] EQ
Drum Voice Edit
Common Edit
[F1] GENERAL
[F2] OUTPUT
[F3] EQ
[F4] CTL SET
[F6] EFFECT
Key Edit
[F1] OSC
[F2] PITCH
[F3] FILTER
[F4] AMP
[F6] EQ
Voice Job
[F1] INIT
[F2] RECALL
[F3] COPY
[F4] BULK
Supplementary Information
50
[SF1] CUTOFF
You can apply filter settings to the Drum Voice. The MOXF6/MOXF8 lets you apply a low pass filter and high pass filter to
each individual Drum key.
LPFCutoff (Low Pass Filter Cutoff)
Use this parameter to set a cutoff frequency for the low-pass filter.
Settings: 0 – 255
LPFReso (Low Pass Filter Resonance)
Determines the amount of Resonance (harmonic emphasis) applied to the signal at the Cutoff Frequency.
Settings: 0 – 127
HPFCutoff (High Pass Filter Cutoff)
Determines the Cutoff frequency of the High Pass Filter.
Settings: 0 – 255
[SF2] VEL SENS (Velocity Sensitivity)
LPFCutoff (Low Pass Filter Cutoff)
Set the velocity sensitivity of the Low Pass Filter Cutoff frequency. Positive settings will cause the Cutoff Frequency to
rise the harder you play the keyboard. A negative setting will have the opposite effect.
Settings: -64 – +0 – +63
[SF1] LVL/PAN (Level/Pan)
This display not only lets you make basic Level and Pan settings for the sound of each individual Drum key, it also gives
you some detailed and unusual parameters for affecting Pan position.
Level
Determines the output for the selected Drum key (Wave). This lets you make detailed balance adjustments among the
various sounds of the Drum voice.
Settings: 0 – 127
Pan
Sets the pan position (stereo position) of each wave. This will also be used as the basic Pan position for the Alternate
and Random settings.
Settings: L63 (far left) – C (center) – R63 (far right)
AlternatePan
Determines the amount by which the sound of the selected Drum key is panned alternately left and right for each note
you press. The Pan setting (above) is used as the basic Pan position.
Settings: L64 – C – R63
RandomPan
Determines the amount by which the sound of the selected Drum Key is panned randomly left and right for each note
you press. The Pan setting (above) is used as the Center Pan position.
Settings: 0 – 127
[SF2] VEL SENS (Velocity Sensitivity)
Level (Level Velocity Sensitivity)
Determines the velocity sensitivity of the Amplitude Envelope Generator's output level.
Settings: -64 – +0 – +63
[F3] FILTER
[F4] AMP (Amplitude)