Filter
Top Products
PERF SONG PATTERN MIX MASTER REMOTE UTILITY
QUICK SET
FILEVOICE
MOXF6/MOXF8 Reference Manual
Performance Mode
Performance Play
[F1] PLAY
[F2] VOICE
[F3] PORTA
[F4] EG
[F5] ARP ED
[F6] EFFECT
Arpeggio Edit
[F1] COMMON
[F2] TYPE
[F3] MAIN
[F4] LIMIT
[F5] PLAY FX
[F6] OUT CH
Performance Edit
Common Edit
[F1] GENERAL
[F2] OUT/MFX
[F3] MEQ
[F4] USB I/O
[F5] A/D IN
[F6] EFFECT
Part Edit
[F1] VOICE
[F2] OUTPUT
[F3] EQ
[F4] TONE
[F5] RCV SW
Performance Job
[F1] INIT
[F2] RECALL
[F3] COPY
[F4] BULK
Performance Record
[F1] SETUP
[F2] REC TR
[F3] OTHER
[F5] CLICK
[F6] INFO
Supplementary Information
56
From this mode you can select a Voice for each Part and determine the note range it can be played from.
Performance Name
Indicates the selected Performance name.
Part
Indicates the selected part.
Part Switch
Determines whether the Part is used (on) or not used (off). Setting this parameter to on ( ) enables the Part to sound.
Meanwhile, setting this parameter to off ( ) disables sound for the Part, and the Part indication will disappear from the
VOICE display.
Voice Bank
Voice Number
Voice Name
Indicates the bank and number of the Voices assigned to Parts 1 – 4.
Note Limit
Determines the lowest and highest notes in the Part’s note range. Simultaneously hold down [SF4] LIMIT L (Limit Low)
and press the desired key on the keyboard to set the note. This sets the lowest note of the range over which the Voice of
the selected Part sounds. Simultaneously hold down [SF5] LIMIT H (Limit High) and press the desired key on the
keyboard to set the note. This sets the highest note of the range over which the voice of the selected part sounds. You
can also create a lower and an upper range for the Voice, with a note range “hole” in the middle, by specifying the
highest note first. For example, setting a Note Limit of “C5 – C4” lets you play the Voice from two separate ranges: C -2
to C4 and C5 to C8. Notes played between C4 and C5 do not play the selected Voice
PortaSw (Portamento Switch)
Determines whether Portamento is on or off for all Parts.
Settings: off, on
PortaTime (Portamento Time)
Determines the pitch transition time or rate when Portamento is applied. The settings are applied as offsets to same
parameter in Performance Part Edit (page 65).
Settings: 0 – 127
PartSwitch
Determines whether Portamento is on or off for each individual Part. This is available only when the PortaSw (above) is
set to on.
This display contains the basic EG settings, both volume and filter. The settings made here are applied as offsets to the
AEG and FEG settings in the Performance Part Edit (page 68). The parameters are the same as in the [F4] EG display of
Voice Play. See page 26.
[F2] VOICE
[F3] PORTA (Portamento)
[F4] EG
Knob