Filter
Top Products
C-1
Catalyst 2960 and 2960-S Switch Software Configuration Guide
OL-8603-09
APPENDIX
C
Unsupported Commands in
Cisco IOS Release 12.2(55)SE
This appendix lists some of the command-line interface (CLI) commands that appear when you enter the
question mark (?) at the Catalyst 2960 or 2960-S switch prompt but are not supported in this release,
either because they are not tested or because of switch hardware limitations. This is not a complete list.
These unsupported commands are listed by software feature and command mode:
• Access Control Lists, page C-1
• Boot Loader Commands, page C-2
• Debug Commands, page C-2
• IGMP Snooping Commands, page C-2
• Interface Commands, page C-3
• MAC Address Commands, page C-3
• Miscellaneous, page C-4
• Network Address Translation (NAT) Commands, page C-4
• QoS, page C-4
• RADIUS, page C-5
• SNMP, page C-5
• SNMPv3, page C-6
• Spanning Tree, page C-6
• VLAN, page C-6
• VTP, page C-7
Access Control Lists
Unsupported Privileged EXEC Commands
access-enable [host] [timeout minutes]
access-template [access-list-number | name] [dynamic-name] [source] [destination] [timeout minutes]
clear access-template [access-list-number | name] [dynamic-name] [source] [destination].