Filter
Top Products
840 USE 106 00 January 2003 61
5
Installation
How to Install a Hot Standby System
Procedure This section discusses the procedure for installing a new Hot Standby system. For
more detailed instructions, refer to the
Quantum Automation Series Hardware
Reference Guide
, 840 USE 100 00 or the
Remote I/O Cable System Planning and
Installation Guide
, 890 USE 101 00.
Installing a Hot
Standby System
Install the power supplies, controllers, RIO head processors, hot standby
modules and any option modules in the primary and standby backplanes. Be
sure:
The modules meet the version requirements listed in
Overview of Quantum Hot
Standby, p. 13
.
The modules in the primary backplane are identical to those in the standby
backplane.
Note: The order of the modules in the backplanes must be the same.
The rotary address switches on the back of each controller are set. The
controllers may have different addresses. It is strongly recommended that the
rotary address switches be set to the same address to eliminate any network
address conflicts. The same advice applies to the NOM. For details on setting
the switches, see the
Quantum Automation Series Hardware Reference Guide
or the
Remote I/O Cable System Planning and Installation Guide
.