Filter
Top Products
Using a Quantum IEC Hot Standby System
112
840 USE 106 00 January 2003
Loading the Software
Loading and
Concept 2.5
Starting with Concept 2.5, the CHS loadable is a part of the Concept install.
If you are using Concept 2.5 and for some reason the loadable is deleted, it can be
reinstalled using the following procedure.
Load Software
into Controllers
To configure a Quantum Hot Standby system, load the CHS software into the
controllers. The software is included on a diskette in the Hot Standby Kit.
Once you have installed the software, you can activate the IEC Hot Standby
configuration extension.
Installing the
CHS loadable
into the Concept
Environment
The following steps are only necessary if the CHS loadable is not already part of
your Concept installation. The CHS loadable is provided on a 3 1/2" diskette
(140 SHS 945 00) as part of your 140 CHS 210 00 Hot Standby kit. The file is named
QCHSVxxx.DAT, where xxx is the three-digit version number of the software.
Step Action
1 Insert the diskette in the disk drive.
2 Either create a new Concept project or open an existing one and have a PLC
selected
3 With the menu command Project Configurator, open the configurator.
4 With Configure Loadables, open the dialog box Loadables.
5 Press the command button Unpack to open the standard Windows dialog box,
Unpack Loadable File. Select the loadable file, click the button OK and it is
inserted into the list box Available.