Filter
Top Products
Black plate (85,1)
Model "S51-D" EDITED: 2008/ 3/ 26
specified by INFINITI could affect the
proper operation of the TPMS.
CAUTION
. The TPMS is not a substitute for the
regular tire pressure check. Be sure to
check the tire pressure regularly.
. If the vehicle is being driven at speeds
of less than 16 MPH (25 km/h), the
TPMS may not operate correctly.
. Be sure to install the specified size of
tires to the four wheels correctly.
Master warning light
When the ignition switch is in the ON
position, the master warning light illumi-
nates if any of the following are displayed
on the dot matrix liquid crystal display:
. No key warning
. Low fuel warning
. Low washer fluid warning
. Parking brake release warning
. Door/lift gate open warning
See “DOT MATRIX LIQUID CRYSTAL DIS-
PLAY” later in this section.
Preview Function warning
light (orange; if so equipped)
The light comes on if there is a malfunction
in the Brake Assist (with Preview Function)
system.
If the warning light comes on, park the
vehicle in a safe place. Turn the engine off,
restart the engine, then resume driving.
If it is not possible to set the system or the
indicator stays on, it may indicate that the
system is malfunctioning. Although the
vehicle is still driv eable und er normal
conditions, have the vehicle checked at
an INFINITI dealer.
Rear Active Steer warning
light (if so equipped)
If the light comes on while the engine is
running, it may indicate that there is a
malfunction with the Rea r Active Steer
portion of the steering system. Have the
system checked by an INFINITI dealer.
For further information about the Rear
Active Steer system, see “REAR ACTIVE
STEER SYSTEM” in the “5. Starting and
driving” section.
If a malfunction occurs in the system, the
Rear Active Steer function will cease but
driving can be continued.
If the light comes on while you are driving,
contact an INFINITI dealer for repair.
Seat belt warning light and
chime
The light and chime remind you to fasten
seat belts. The light illuminates whenever
the ignition switch is pushed to the ON
position, and will remain illuminated until
the driver’s seat belt is fastened. At the
same time, the chime will sound for about
6 seconds unless the driver’s seat belt is
securely fastened.
The seat belt warning light for the front
passenger will illuminate if the seat belt is
not fastened when the front passenger’s
seat is occupied. For 5 seconds after the
ignition switch is in the ON position, the
system does not activate the warning light
for the front passenger.
See “SEAT BELTS” in the “1. Safety —
Seats, seat belts and supplemental re-
straint system” section for precautions on
seat belt usage.
Instruments and controls 2-17