Filter
Top Products
Black plate (46,1)
Model "S51-D" EDITED: 2008/ 3/ 26
SSS0641
Frontfacing —step 8
8. Before placing the child in the child
restraint, hold the child restraint near
the seat belt path and use force to push
the child restraint from side to side,
and tug it forward to make sure that it
is securely held in place. It should not
move more than 1 in (25 mm). If it does
move more than 1 in (25 mm), pull
again on the shoulder belt to further
tighten the child restraint. If you are
unable to properly secure the restraint,
move the restraint to another seating
position and try again, or try a different
child restraint. Not all child restraints fit
in all types of vehicles.
9. Check that the retractor is in the ALR
mode by trying to pull more seat belt
out of the retractor. If you cannot pull
any more belt webbing out of the
retractor, the retractor is in the ALR
mode.
10.Check to make sure the child restraint
is properly secured prior to each use. If
the seat belt is not locked, repeat steps
3 through 8.
SSS0676
Frontfacing —step 11
11.If the child restraint is installed in the
front passenger seat, push the ignition
switch to the ON position. The front
passenger air bag status light
should illuminate. If this light is not
illuminated, see “Front passenger air
bag and status light” l ater in this
section. Move the child restraint to
another seating position. Have the
system checked by an INFINITI dealer.
After the child restraint is removed and the
seat belt is fully retracted, the ALR mode
(child restraint mode) is canceled.
1-30 Safety — Seats, seat belts and supplemental restraint system