Filter
Top Products
Black plate (135,1)
Model "S51-D" EDITED: 2008/ 3/ 26
the programmed HomeLink
®
button -
releasing when the device begins to
activate.
5. If the indicator light on HomeLink
®
blinks rapidly for two seconds and then
turns solid, HomeLink
®
has picked up a
“rolling code” garage door opener
signal. You will need to proceed with
the next steps to train HomeLink
®
,
completing the programming may re-
quire a ladder and another person for
convenience.
6. Push and release the program button
located on the garage door opener’s
motor to activate the “training mode”.
This button is usually located near the
antenna wire that hangs down from the
motor. If the wire originates from under
a light lens, you will need to remove the
lens to access the training button.
NOTE:
Once you have pushed and released
the training button on the garage door
opener’s motor and the “training light”
is lit, you have 30 seconds in which to
perform step 7. For convenience, use
the help of a second person to assist
when performing this step.
7. Quickly (within 30 seconds of pushing
and releasing the garage door opener
training button) and firmly push and
release the HomeLink
®
button you’ve
just programmed. Push and release the
HomeLink
®
button up to three times to
complete the training.
8. Your HomeLink
®
button should now be
programmed.To program the remaining
HomeLink
®
buttons for additional door
or gate openers, follow steps 2 through
8 only.
NOTE:
Do not repeat step 1 unless you want to
“clear” all previously programmed
HomeLink
®
buttons.
If you have any questions or are having
difficulty programming your HomeLink
®
buttons, please refer to the HomeLink
®
web site at: www.homelink.com or call 1-
800-355-3515.
PROGRAMMING HomeLink
®
FOR
CANADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required
hand-held transmitters to stop transmitting
after 2 seconds. To program your hand-
held transmitter to HomeLink
®
, continue to
push and hold the HomeLink
®
button (note
steps 2 through 4 under “Programming
HomeLink
®
”) while you push and re-push
(“cycle”) your hand-held transmitter every
2 seconds until the indicator light flashes
rapidly (indicating successful program-
ming).
NOTE:
If programming a garage door opener, etc.,
it is advised to unplug the device during
the “cycling” process to prevent possible
damage to the garage door opener com-
ponents.
OPERATING THE HomeLink
®
UNI-
VERSAL TRANSCEIVER
HomeLink
®
Universal Transceiver (once
programmed) may now be used to activate
the garage door, etc. To operate, simply
push the appropriate programmed
HomeLink
®
Universal Transceiver button.
The red indicator light will illuminate while
the signal is being transmitted.
PROGRAMMING TROUBLE-DIAGNO-
SIS
If HomeLink
®
does not quickly learn the
hand-held transmitter information:
. replace the hand-held transmitter bat-
teries with new batteries.
. position the hand-held transmitter with
its battery area facing away from the
HomeLink
®
surface.
Instruments and controls 2-67