Filter
Top Products
Black plate (40,1)
Model "S51-D" EDITED: 2008/ 3/ 26
SSS0646
Frontfacing —step 2
2. Secure the child restraint anchor at-
tachments to the LATCH lower anchors.
Check to make sure the LATCH attach-
ment is properly attached to the lower
anchors.
3. The back of the child restraint should
be secured against the vehicle seat-
back. If necessary, adjust or remove the
head restraint to obtain the correct
child restraint fit. (See “HEAD R E-
STRAINT” earlier in this section.)
If the head restraint is removed, store it
in a secure place. Be sure to install the
head restraint when the child restraint
is removed. If the seating position does
not have an adjustable head restraint
and it is interfering with the proper
child restraint fit, try another seating
position or a different child restraint.
SSS0647
Frontfacing —step 4
4. For child restraints that are equipped
with webbing mo unted attachments,
remove any additional slack from the
anchor attachments. Press downward
and rearward firmly in the center of the
child restraint with your knee to com-
press the vehicle seat cushion and
seatback while tightening the webbing
of the anchor attachments.
5. If the child restraint is equipped with a
top tether strap, route the top tether
strap and secure the tether strap to the
tether anchor point. (See “TOP TETHER
STRAP CHILD RESTRAINT” earlier in this
section.)
1-24 Safety — Seats, seat belts and supplemental restraint system