Filter
Top Products
Black plate (462,1)
Model "S51-D" EDITED: 2008/ 3/ 26
STI0585
Use the fol lowing steps to mount the
license plate.
Before mounting the license plate, confirm
that the following par ts are enclosed in the
plastic bag.
Only use the recommended mounting
position, otherwise Intelligent Cruise Con-
trol (ICC) sensor obstruction (if so
equipped) may result.
. License plate bracket
. J-nut 6 2
. Screw 6 2
. Screw grommet 6 2
1. Park the vehicle on flat, level ground.
2. Locate the center position indicator
*
A
on the lower part of the grille. Line up
the marks under the top of the front
bumper
*
B
with the tabs
*
C
on the
license plate bracket. Hold the license
plate bracket in place.
3. Mark the center of the hole
*
C
with a
felt-tip pen.
4. Carefully drill two pilot holes using a
0.39 in (10 mm) drill bit at the marked
locations. (Be sure that the drill only
goes through the bumper fascia.)
5. Insert grommets into the hole on the
INSTALLING FRONT LICENSE PLATE
9-14 Technical and consumer information