Filter
Top Products
Connect the Battery
Use the
9-volt battery that’s included. BE SURE TO TEST IT
FIRST!
Enter the Wireless Siren /Controller
Test Mode
1. Press the internal ‘CANCEL’ button. Hold it for 6 SECONDS.
The
Wireless Siren/Controller will beep once when the button is
pressed and again when it goes into the TEST MODE.
2. Listen for the Wireless Siren/Controller Test Mode indication
beeps to begin. There will be one beep every
40
seconds.
Test the RF Link
1. Press the Test/Demo key on the Central Controller.
2
.
Listen for the verification beeps from the Wireless
Siren/Controller.
1 Beep =
Excellent RF link
2 Beeps =
Excellent RF
link
Low Battery
No Beeps =
No RF message
Relocate Wireless Siren/Conrollerr
until 1 Beep is heard
NOTE: 8 beeps indicate the Central Controller has failed to check
in. This can only happen after the initial installation of the system.
Exit
Wireless Siren/Controller Test Mode Press the internal
"CANCEL"
button on the Wireless
Siren/Controller.
AT&T Proprietary Information
2-74