Filter
Top Products
b. Plug each security code post into the slot for the number
desired.
Blue Wiie
=
First Number
White Wire
=
Second Number
Yellow Wire
=
Third Number
NOTE: The proper wire sequence is easy to remember since
the
alphabetical order of the colors is the same as the order of the
numbers they represent:
1st = B
2nd = W
3rd =
Y
3.
Check the voltage on the 9 volt battery using your meter.
It
should register 9 volts. Then connect the 9 volt battery.
Check the current draw.
4.
Log the transmitter location on the Central Controller Zone
Locator Card.
5.
Temporarily place the transmitter in the area that it
will
be
mounted. Use double-sided tape to hold it (gently- it might
pull off the wall board!) if necessary.
6. Enter the Installer Test Mode, as described below.
a.
Enter the transmitter security code and then press
the Off key to put the system in the Off state.
NOTE: Next, quickly press the Test/Demo key (Step b.). If it is
held down for more than 3 seconds, the Demonstration Mode will
be entered, instead of the Installer Test Mode and a ‘-0.” will
appear in the digital display.
To clear this condition: Press the Test/Demo key once to exit the
Demo Mode.
AT&T Proprietary Information
2-47