Filter
Top Products
STEP
10
Enter the Installer Test Mode
a. Enter the transmitter security code and then press the OFF key
to put the system in the OFF state.
b. Press the Test/Demo key on the Central Controller. The
digital display will show an ‘88’.
Note: Quickly press the Test/Demo key. If it’s held down for
more than 3 seconds, the Demonstration Mode will be entered
instead of the installer Test Mode and a “-0.” will appear in the
digital display.
c. Touch alI four keys on the Central Controller at the same time
(Messages, Clear Display, Cancel, and Test/Demo). The digital
display will show a ‘CC’. See illustration below.
d. Listen for the Installer Test Mode
indiation
beeps to start.
There will be one beep every forty seconds.
AT&T Proprietary information
2-27