Filter
Top Products
STEP 17
Program
the Transmitters
Identification Codes
An easy way to program the transmitters is to begin by setting the
I.D. code for each one while you have them all together (in the
kitchen of wherever you’re working). That way, since you can look
at them ail at once, you’ll be sure not to give the same I.D. number
to more than one transmitter.
Let’s look at the
I.D.
Code for a moment.
Each transmitter in the system must have a unique code number.
Fivee DIP switches are used to program the transmitter I.D. The
I.D. number is used by the Central Controller to relay trouble
beeps and alarms to specific transmitters. Code numbers 00
through 31 may be used. Codes
00
through 23 are shown below.
The
Supervised
Smoke Detector Transmitter differs from the other
transmitters in that it only has three I.D. DIP
switchess
and only
uses code numbers 24 through 31. These codes are shown on Page
62.
Transmitter
ID
Switch
Settings
ID
Code
1 2 3 4 5
00 ON ON ON ON ON
01 OFF ON ON ON ON
02 ON OFF ON ON ON
03 OFF OFF ON ON ON
04 ON ON OFF ON ON
05 OFF ON OFF ON ON
06 ON OFF OFF ON ON
07 OFF OFF OFF ON ON
08 ON ON ON OFF ON
09 OFF ON ON OFF ON
10 ON OFF ON OFF ON
11 OFF OFF ON OFF ON
12 ON ON OFF OFF ON
13 OFF ON OFF OFF ON
14
ON OFF OFF OFF ON
15 OFF OFF OFF OFF ON
16 ON ON ON ON OFF
17 OFF ON ON ON OFF
18 ON OFF ON ON OFF
19 OFF OFF ON ON OFF
20 ON ON OFF ON OFF
21 OFF ON OFF ON OFF
22 ON OFF OFF ON OFF
23 OFF OFF OFF ON OFF
24 ON ON ON OFF OFF
25 OFF ON ON OFF OFF
26 ON OFF ON OFF OFF
27 OFF OFF ON OFF OFF
27 OFF OFF ON OFF OFF
28 ON ON OFF OFF OFF
29 OFF ON OFF OFF OFF
30 ON OFF OFF OFF OFF
31 OFF OFF OFF OFF OFF
AT&T Proprietary Information
2-42