Filter
Top Products
Mount
Supervised
Smoke
Detector
Transmitter
1.
Remove
the back bracket from the detector.
Use the release tab
marked
"Press"
to remove back for
mounting.
2.
Mount the detector bracket.
3. Install the detector onto the bracket.
4.
Perform second RF
link
test.
a. Use a pencil to press the Test button on the front of
the detector.
b.
Listen for the proper number of
beeps
from the
Central
Controller.
C
.
Check the Central ControlIer to verify that the
proper transmitter I.D. number appears.
d.
Check the status LEDs on the Central Controller for
more information.
STEP 19
Exit the Installer Test Mode
1.
Use the MESSAGES key on the Central Controller to scroll
through the I.D. numbers.
- If any are missing, go back and RE-test that transmitter
now.
-
To remove unwanted numbers, press the CLEAR
DISPLAY key now.
2.
Press the Test/Demo key on the Central Controller.
3.
Verify that the Installer Test Mode has been exited
-
Check the Central Controller digital display to
confirm that the ‘CC” has changed to ‘-0” to indicate
that the system is in the Off state.
-
Listen to verify that the Installer Test Mode
indication beeps have stopped.
AT&T Proprietary Information
2-71