Filter
Top Products
4.
5.
Connect sensor wires to the screw terminals on the
backplate for the
desired type of sensor
loop.
If wiring the 24-hour sensor loop, the preinstalled jumper
must be removed. Otherwise, make sure the 24-hour
jumper is firmly installed.
Connect the snap caps or spade lug wires to the screw
terminals.
The snap caps and wires are color coded
for each
terminal.
CAUTION: The wires should not end up on top of (or under) the
]
battery or on the tamper switch
-
could cause false alarms.
1
6.
Attach the front housing.
RESPONSE-500 mSEC
-24-Hour
LOOP
‘SELECTABLE
LOOP
USE JUMPERS
TO CLOSE LOOPS
FOR HANDHELD USE
AT&T
Proprietary Information
2-65