Filter
Top Products
3.
Test battery, under load, then connect the 9-volt battery. It
should register 9 volts on your meter. Check the current
draw.
4.
Log
the transmitter location on the central controller Zone
Locator Card.
5.
Temporarily place the transmitter in the area that it will be
mounted. Use double-sided tape if necessary.
6.
Perform the Keypad Transmitter RF link test.
a.
Use a pencil to move the slide switch.
b.
Listen for the proper number of indication beeps
from the Central Controller.
c.
Check the Central Controller to
verify
that the
proper transmitter ID number appears.
d.
Check the status LEDs on the Central controller for
more information.
7.
If the low security option is desired, move DIP switch
8
to
the OFF position.
AT&T Proprietary Information
2-52