Filter
Top Products
If
the auxiliary sounding device
requires
more powcr
than
450
MA,
then install the High Power Siren
Relay Module
Use
the
following
procedure:
1.
Peel off the tape backing.
2.
Mount anywhere on the inside of the Central controller
plastic housing. Do not mount on a metal surface.
3.
Connect the
red and black wire leads to a UL-listed
external power supply.
4.
Connect
the
blue wire to the
Central Controller screw
terminal
7(
+).
5.
6.
Connect the brown wire to the Central Controller screw
terminal 10 (-).
While the
auxiliary sounding device to the High Power
Siren Relay Module screw terminals (-)
and 2
(+).
NOTE Look at the following diagram showing the High Power
Siren Relay Module properly connected.
STEP 16
Recheck
All
Transmitter
Locations
See Step
12
for instructions
(p.
2-36).
AT&T Proprietary Information
2-41