Filter
Top Products
8.
Activate the LED by connecting the walk-test LED plug
to the ‘Active” post on the PIRT circuit board.
9
.
Check to see that DIP switch 7 is set in the OFF
position.
10.
Temporarily mount the PIRT with double-sided tape.
11. Perform the PIRT RF link test.
a.
Slowly move your hand in front of the PIRT until
the walk-test LED comes on.
b.
Listen for the proper indication beeps from the
Central Controller.
c.
Check the Central Controller to verify that the
proper transmitter ID number appears.
d.
Check the status LEDs on the Central Controller
for more information.
12. Fill unused screw holes to keep out bugs and dust.
AT&T Proprietary Information
2-60