Filter
Top Products
3.
Mount the backplate.
Be careful not to over-tighten the backplate
screws.
4.
Connect sensor wires, if used, to the screw terminals on
the backplate.
5.
Connect the snap caps or spade lug wires to the screw
terminals.
6.
Attach the front housing.
7.
Perform the sensor activation RF test.
a.
Activate the sensor.
b.
Listen for the proper number of beeps from the
Central Controller.
c
Check the Central
Controller
to verify that the
proper transmitter I.D. number appears.
d.
Check the status
LEDs
on the Central Controller
for more information.
AT&T Proprietary Information
2-68