Filter
Top Products
STEP 13
Install Sensors that Utilize the Central
Controller hardwired Loop and
Auxiliary Power
1.
2.
Select sensor location.
Remove all power to Central Controller before installing
sensor.
3.
Connect hardwired loop sensor wire to the Central
Controller.
.
Use screw terminals 5 and 6.
4.
Connect auxiliary power wire to the Central Controller.
.
Use screw terminals
11
(+)
and
12 (-).
5.
Reconnect power to Central Controller.
6.
Test the sensor to see if it causes an alarm.
If not, check voltage on 11 and 12.
AT&T Proprietary Information
2-37